Sany SCC900E - Navayuga

This Sany SCC900E of Navayuga from Doha (QA) was used on a construction site in Doha. It is a 90-tonne crawler crane.

The crane is powered by a QSC8.3-C260-30, a 6-cylinder diesel engine with a power of 194 kW.

Attached to the undercarriage is in total 10 tonnes of centrale counterweight, that exists out of two slabs with each 5 tonnes.

The A-frame has a total height of 6.47 meters measured from the ground. For the transport over the road is it possible to fold the A-frame down. To adjust the angle of the main boom is a 20 mm cable used with a line pull of 7 tonnes.

The crane is fitted with two hoist winches with 24 mm cable and a 9.2-tonne line pull. Both hoists were here also in use.

The 9-part counterweight has a total mass of 30.1 tonens.

The udnercarriage of the crane is 6.33 meters long and 5 meters wide. For the transport over the road is the width to be reduced to 3.49 meters.

The main boom of the crane has a 13 meter base length and can be extended in 3 meter steps to a maximum length of 61 meters. Here is the main boom 40 meters long. In this configuration is the crane able to lift a maximum of 26.7 tonnes on a 13 meter radius and 3.7 tonnes to a 38 meter radius.

A sharp crane of Navayuga!

Back to the Sany SCC-series menu